Wednesday, August 12, 2015

ESXi 6.0 on Apple Xserve crashes

After having lots of problems with my Xserves crashing al lot after having upgraded them to ESXi 6.0, I decided I had to solve this.

Basically ESXi 6.0 with vSphere runs on Xserves.

After some time, i found out that it was not the server crashing.
It was the network connection that went down.

I knew this because a) the server was not dead, no PSOD or anything, and on my secondary network interface, the server was still pingable.

So, what did we do:

The Xserve 3.1 comes with these NICs installed:

Intel Corporation 82574L Gigabit Network Connection

So what we did is exchange the PCI NIC to a
Intel Corporation I350 Gigabit Network Connection


Soon after that, VMware released ESXi 6.0U1.

And what do I read in the Release Notes:

VMware vSphere 6.0 Updated 1 Release Notes
An ESXi host might lose connectivity and e1000e virtual NIC might get reset 
An ESXi host might intermittently lose connectivity and e1000e virtual NIC might get reset. An All Paths Down (APD) condition to NFS volumes might also be observed. An error message similar to the following is written to the vmkernel.log file
packets completion seems stuck, issuing reset
This issue is resolved in this release.

You can check if this might be the case if you enter this in the command line of your server:

  1. esxcli network nic list  

If a driver is listed as «e1000e» then you could try updating to 6.0U1

1 comment:

Unknown said...

Has updating to 6.0U1 solved the problem for you? I'm just getting started with ESXi on an Xserve3,1 with its built-in Ethernet, and I've already experienced a loss of network connection once. 6.0U1 is the only version of ESXi I've tried.